Author Topic: GB plugin bent pins  (Read 2363 times)

Offline wyaman

  • Baby Retrode
  • *
  • Posts: 4
  • Karma: +0/-0
    • View Profile
GB plugin bent pins
« on: 10/Aug/2013 12:15:55 AM »
So I ordered a retrode 2 + gb plugin a little while back, and I finally received it today. The Retrode works great, but the GB plugin has a few bent pins on the right side of the GB slot (with the label facing away from you). Is there a good way to unbend them? As it is now, you can not insert any cartridges.

Here's a link to a picture of the damage:

http://imgur.com/QVTtf3Y

Offline emuDrache

  • Junior Retrode
  • **
  • Posts: 57
  • Karma: +2/-0
    • View Profile
    • database.trurip.org
Re: GB plugin bent pins
« Reply #1 on: 10/Aug/2013 05:56:37 AM »
the pins are fine. its the plastic bits that hold the pins from protruding out too far that are broke.

probably could fix it with a bit of patience and crazy glue, but you should talk to matthias, assuming you ordered your stuff from him.
The goal of database.trurip.org is to catalogue the software of as many classic systems as possible. database.trurip.org does not and will never host ISO or ROM downloads

Offline Matthias_H

  • Retrode Forum Techie
  • A Retrode Hero
  • *****
  • Posts: 546
  • Karma: +21/-0
    • View Profile
Re: GB plugin bent pins
« Reply #2 on: 18/Aug/2013 05:59:03 PM »
As emuDrache said, though I've never seen this issue on production adapters before (only my own kitchen oven ones where the temperature curve is obviously nowhere near the recommended reflow soldering profile). Should this actually be more common than I thought - are there other GB plug-in users who have seen similar damage?

Regards,
Matthias
http://www.retrode.org

I no longer sell the Retrode. For sales inquiries, please contact our friends at DragonBox.