Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - WolfBoy980

Pages: [1]
1
General Discussion / Trouble Updating to v23
« on: 18/Nov/2017 07:10:02 AM »
I've been following the updating steps like the Bible, but I can't seem to get the right results. I've installed the device properly using Flip, and the Retrode 2 enters DFU mode perfectly. But when I attempt to connect to the device, Flip can't open the device!

I updated the driver so the device is named AT90USB64. But from there it gets messy...
Some users have reported that their device updates fine with Flip's AT90USB646 driver detection, but i'm not getting scratch. I've uninstalled and reinstalled the Flip software multiple times and attempted updating the Retrode's DFU driver to only get messages saying I have the best driver installed already.I just can't get it to work, I can't seem to find a solution from anyone else!

I saw some users report it was because of driver incompatibility with Windows 10? Is this still true?

Pages: [1]